So I bought this kinetix plenum used and had to use stock hardware

DAN A4 v4 is not compatible with 14mm fan under MB!! Riser cable has broken! : r/sffpc

First wall mount rack for me. Networx brand. These expansion bolts aren't mentioned on instructions, not even packing list. I'm assuming a type of wall mount, but how is it used?

Just put on a set of alba racing a arms and trx540r shocks and now I have this. How to deal with this camber issue. Any idea how to fix this? 2012

Cutting fork sizing questions with expansion plug : r/bikewrench

Truss rod cavity plug split and fell out. Is my truss rod okay? : r/Luthier

Had to dremel the head off of this shear pin because it bent I suspect it wasn't a shear bolt : r/Justrolledintotheshop

planning 2 mount a pull-up bar (3 anchor bolts each side) on an uneven wall. plan is a chemical resin to anchor the bolts. bottom & middle bolts i believe will be ok. the gap from wall to the strut with the top bolt worries me. any suggestions on what i should 2

Truss rod cavity plug split and fell out. Is my truss rod okay? : r/Luthier

Purchased her from someone and the hood came misaligned. Could it be a hood hinge that's bent? : r/350z

GMW-B5000-1 bezel screws rattle after bezel swap : r/gshock

Is this an issue? 1” uponor. Feel like tool isn't expanding properly but new to system so not sure. Even after bottoming out on ring still doesn't feel “open” enough, supposed to

Finally happened. Inner frame snapped mid-build while working on the RG Wing Gundam Zero EW : r/Gunpla

So when removing the rear sub frame one of the bolts broke How do I fix this? : r/240sx